EasyManua.ls Logo

TOHATSU MFS 8A3 - Daily Inspection Checklist

TOHATSU MFS 8A3
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSPECTION AND MAINTENANCE60
10
ENOM00551-0
Perform the following checks before and
after use.
ENOW00078-0
Do not use outboard motor if any abnor-
mality is found during pre-operation check
or it could result in severe damage to the
motor or severe personal injury.
1. Daily Inspection
WARNING
Item Points to Check Remedy
Fuel System
• Check the amount of fuel in the tank. Replenish
• Check for debris or water in the fuel filters. Clean or Replace
• Check the rubber hoses for fuel leakage. Replace
Fuel Tank Cap
• Check for crack, leakage, damage in the fuel tank cap. Replace
• Check for crack, damage in the gasket and tether. Replace
• Check for leakage at full close. Replace
• Check for ratchet performance. Replace
Engine Oil
• Check the oil level. Fill to the upper level mark
on dipstick
Electrical
Equipment
• Check that the main switch functions normally. Replace
• Check that the battery electrolyte level and specific gravity are
normal.
Replenish or recharge
• Check for loose connections on the battery terminal. Retighten
• Check that the stop switch functions normally and make sure
the lock plate is there.
Remedy or replace
• Check cords for loose connections and damage. Correct or replace
• Check the spark plugs for dirt, wear and carbon build-up. Clean or replace
Throttle Sys-
tem
• Check carburetor linkage is working normally when turning the
throttle grip.
Correct
Recoil Starter
• Check the rope for wear and chafing. Replace
• Check the ratchet engagement. Correct or replace
Clutch and
Propeller Sys-
tem
• Check that clutch engages correctly when operating the shift
lever.
Adjust
• Visually Check propeller for bent or damaged blades. Replace
• Check the propeller nut is tightened and the split pin is present.
Installation of
Motor
• Check all the bolts attaching the motor to the boat. Tighten
• Check the thrust rod installation.
Cooling Water
• Check that cooling water is discharged from the cooling water
check port after the engine has started.
Repair
Tools and
Spares
• Check that there are tools and spare parts for replacing spark
plugs, the propeller, etc.
• Check that you have the spare rope.
Steering
Devices
• Check the operation of the steering handle. Repair
Other parts
• Check if the anode is securely installed. Repair if necessary
• Check the anode for corrosion and deformation. Replace
MFS6-8-99A3_EUR_EN_141114N.book 60 ページ 2014年12月13日 土曜日 午後5時49分