MAGLINK LX
Configuration Manual | "Admin" Pages
Rev. 09,
– April 2016
Page 16 of 28
8.2
Tank
The following image shows the "Tank Page":
The page allows you to set the data of each tank; Select from the drop down "Tank,” for the tank you wish
to work on and then set the parameters listed in the following table:
Parameter Description
Enabled
When the flag is active, the application queries the corresponding probe during
the read cycle, otherwise the probe is not queried
Description Description of the tank
Address Address of the probe (no reading from probe in case of incorrect address)
Product Type Select the type of product contained in the tank from the list
Density Product density, fixed value defined by the product type selection
Total capacity* Maximum volume of the product (read-only value)
Maximum height* Maximum level of the product (read-only value)
Offset
Value used to calibrate the position of the product float
Possible values: ±30.000 mm
Zero water
Value used to calibrate the water float
Resolution: 1 mm. Maximum value: +30.000 mm
Probe type
Select from the following (This decision impacts the diagnostics display page on
the console, refer to the user manual):
• Laser probe • Logger • Normal • RF
Very high alarm, High alarm, Low alarm, Very
low alarm, Water alarm
Set alarm values relating to different thresholds
Delta vol., Delta leakage Set the minimum values to trigger a loss or leakage
Working Capacity Set the working capacity for the Ullage calculation
DVD Configuration ID, offset and Maximum Confidence probe (Data provided by Start Italiana S.r.l.)
*This parameter cannot be set, it is taken from the last line of the strapping table (See Strapping Table section); In case of no
Strapping Table, it is possible to create a simple one, with only two lines:
mm 0 litres 0 Add row
mm Maximum height of tank litres Maximum volume capacity Add row
To Next Page
Loading...
