Tokheim ProGauge MAGLINK LX - Relays; Sensors

MAGLINK LX Configuration Manual | "Admin" Pages
Rev. 09,
– April 2016 Page 18 of 28
ATTENTION: Press the "Save strapping table" button to apply the changes; Otherwise, the changes are
lost.
ATTENTION: The strapping table can have a maximum of 500 points
The button allows you to download the " Strapping Table" in an Excel file in CSV format.
8.4 Relays
The following image shows the "Relay Page":
Configuring alarm relays, select the tank from the "tank" drop-down list and wait for data to load, then set
the desired alarms. Relays can be configured for the following:
•
Not used
•
Low
•
Very high
•
Water
•
No link
•
Out of range
•
Very low
•
High
•
Probe
•
Communication
ATTENTION: When using the DVD, do not use Relay 4 as its used to power the DVD
8.5 Sensors
In this section user can configure internal and external sensors. User must select a sensor type and for each
sensor define the alarm status. In addition user can select a relè to combine with each sensor when alarm is
active.
You can specify the sensors connected to the console. Select the sensor from the "sensor type" drop-down
list and fill in the fields related to sensors. The types of sensors available are as follows:
• Internal: Internal probe (6 sensors)
• Triple-state: Triple-state probe (64 sensors)
• External Card Start Italiana S.r.l.: External card supplied by Start Italiana S.r.l. (up to 32 sensors)
The following image shows the "Sensors" page (Internal sensor type):