If the name is not in the list, then say "Back" or "No" or tap Back to return to the previous screen
and say the town again when you hear the tone.
4. Say the streetname.
Your TomTom Connect shows a list of streetnames which sound similar to what you said and
tells you which streetname is at the top of the list.
If the streetname you hear is the same as the streetname you requested then say, "Done" or "OK"
or "Yes" or "One" or tap the streetname at the top of the list.
Tip: Different locations may have the same name, such as a road that spans multiple post-
codes. When this happens you need to look at the screen and tap the correct location.
If the street name you hear is incorrect, but the correct streetname is in the list, say the num-
ber next to the correct streetname or tap the streetname in the list.
If the streetname is not shown in the list, say "Back" or "No" or tap Back to return to the previ-
ous screen and then say the streetname again when you hear the tone.
5. Say the house number.
Important: Numbers need to be spoken in the same language as the button names and menus
on your TomTom Connect.
Numbers should be pronounced in the same way you normally say a number, in one continuous
sentence. So 357 is pronounced, "Three hundred and fifty seven."
If the number is shown correctly then say, "Done" or "OK" or tap the keyboard to enter the num-
ber.
If the number is shown incorrectly then say, "Back" or "No" or tap the Backspace key and repeat
the number.
Tip: If you say, "Back" when there are no numbers on the screen, your TomTom Connect will
return you to the previous screen.
When the number is shown correctly say, "Done" or "OK." Alternatively, enter the number by
tapping the screen.
6. When the route has been calculated and the route summary is shown, tap Done.
Your TomTom Connect starts to guide you to your destination, using spoken instructions and on-
screen directions.
Tip: In addition to planning a route using Voice control, you can tap Navigate to in the Main
menu and then tap Spoken Address. Alternatively you can tap the button at the base of the key-
board during address entry. When the button is grey, you cannot use speech to enter an address.
To Next Page
Loading...
Need help?
General
