TomTom GO 510 User Manual

22
•
•
•
•
•
•
Travel via...
Tap this button to change your route so that it passes a particular location.
Perhaps you want to pick someone up on the way, or stop for lunch.
You choose the location you want to pass in the same way as you choose a
destination. So you can select from all the same options: for example,
Address, Favourite, Point of Interest and Point on map.
Using this button, you can only travel via one location. If you want to pass
more than one, use an Itinerary. For more information, see Itinerary
planning on page 23.
Recalculate
original
Tap this button to return to the original route without any deviations for
roadblocks or deviations to travel via particular locations.
Avoid part of
route
Tap this button to avoid a part of the route. Use this button if you see that
your route includes a road or junction you don’t like, or which is well-known
for traffic problems.
You then choose the road you want to avoid from a list of the roads on your
route.
Minimise
traffic delays
Tap this button to recalculate your route so that it avoids traffic problems as
much as possible. Your GO will check if there are any traffic problems on
your route and work out the best route to avoid the problems.
For more information about using TomTom Traffic, see TomTom Traffic on
page 59.

TomTom GO 510 Specifications

General

Outdoor (hiking, trekking)	Yes
Marine (chartplotters, sounders)	No
Display resolution	480 x 272 pixels
Display number of colors	65536 colors
Display size (HxV) (imperial)	4.0 \
Processor frequency	400 MHz
Battery life (max)	4 h
Product color	Gray

Weight and Dimensions

Depth	81 mm
Width	112 mm
Height	66 mm
Weight	300 g