EasyManua.ls Logo

TomTom Rider 400 - Map Share; About Map Share; Creating a Map Correction Report

TomTom Rider 400
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
126
About Map Share
You can report map changes using Map Share. These map changes are then shared with other
TomTom device users when they receive a map update.
There are two ways to report a map change:
Select a location on the map and create the change report immediately.
Mark a location and create the change report later.
To send your map change reports to TomTom, you must connect your Rider to your computer and use
MyDrive Connect.
All map changes are verified by TomTom. These verified changes are then available as part of the
next map update which you can get when you connect your device to MyDrive Connect using a USB
connection.
Tip: If a roadblock is reported using Map Share, the roadblock is verified and immediately shown by
TomTom Traffic.
Creating a map correction report
Important: For safety reasons, do not enter the full details of a map correction while you are driving.
You can always mark the location and create the report later.
To create a map correction report, do the following:
1. Press and hold to select the location of the map correction on the map view.
2. Select the pop-up menu button to open the menu.
3. Select Report Map Change from the pop-up menu.
4. Select the type of map correction you want to apply.
Map Share

Table of Contents

Other manuals for TomTom Rider 400

Related product manuals