Tool-Temp TT-188 - General Information and Safety

Manual of instructions TT-188 2/37
General information
This documentation is copyrighted. Unauthorised duplication is prohibited by law. To the best of our
knowledge and belief, the information contained in this documentation is true and correct as of the
date of publication. The contents, however, do not constitute a binding obligation on the part of
TOOL-TEMP AG and are subject to change without notice.
In case of inconsistencies in the English translation, the German version shall prevail.
© Copyright 2018 TOOL-TEMP AG
Contents
1. General Safety Information ........................................................................................................... 4
1.1. Safety Symbols .................................................................................................................................................................. 4
1.2. Range of Application .......................................................................................................................................................... 4
1.3. Intended Use ..................................................................................................................................................................... 4
1.4. Safety Information .............................................................................................................................................................. 5
1.4.1. General Information .................................................................................................................................................. 5
1.4.2. Process Monitoring ................................................................................................................................................... 5
1.4.3. Information for Operators and Personnel .................................................................................................................. 5
1.4.4. Changing the Parameterisation ................................................................................................................................ 6
1.4.5. Residual risks ........................................................................................................................................................... 6
1.5. Using this Documentation .................................................................................................................................................. 7
1.5.1. Additional Documentation ......................................................................................................................................... 7
2. Overview temperature control unit .............................................................................................. 8
2.1. Front view .......................................................................................................................................................................... 8
2.2. Rear view......................................................................................................................................................................... 10
2.3. Identification of residual risk on the unit ........................................................................................................................... 11
3. Technical Specifications ............................................................................................................. 12
4. EU – Declaration of conformity .................................................................................................. 13
5. Installation .................................................................................................................................... 14
5.1. Installing and dimensions of the temperature control unit ................................................................................................. 14
5.2. Connections ..................................................................................................................................................................... 15
5.3. Power supply ................................................................................................................................................................... 16
5.4. Initial operation - Filling .................................................................................................................................................... 16
5.4.1. Pump rotation check ............................................................................................................................................... 17
5.4.2. Display of pump pressure ....................................................................................................................................... 17
5.5. Initial operation with heat transfer oil (Oil operation) ......................................................................................................... 18
5.5.1. Close the automatic filling ....................................................................................................................................... 18
5.5.2. Change stage switching (according to the electrical diagram) ................................................................................. 18
5.5.3. Switching of the heating stages (according to the electrical diagram) ..................................................................... 18
6. Operations .................................................................................................................................... 19
6.1. Overview MP-888 ............................................................................................................................................................ 19
6.2. Parameter settings MP-888 – flow controller 1.5…35 l/min .............................................................................................. 21
6.3. Parameter settings MP-888 – flow controller 4…65 l/min ................................................................................................. 23
6.4. Setting of the temperature – Heating / Cooling ................................................................................................................. 25
6.5. Adjustment of electronic flow control ................................................................................................................................ 25
6.6. Mould drainage – Changing the consumer ....................................................................................................................... 26