ToolKitRC MC8 - PPM Signal output

@ToolkitRC 2021
15
2，PPM Signal output
From the PWM output page, short press on PWM to
change the output type; scroll right until PPM is
displayed. Short press to confirm the PPM selection, as
shown below:
In the PPM output page, press down on the roller for 2
seconds to set the output value of each channel.
===================================
1 ， The throttle channel can only be controlled
using the signal from the output slider; the value
cannot be changed using the roller for safety reasons.
2，Ensure the output slider is at its lowest point prior to
performing any tests.
===================================