Topcom SOLOGIC B935 - Removing a Handset; Selecting a Base Unit; Multiple Handset Usage

Sologic B935 23
Sologic B935
ENGLISH
13.2 Removing a handset
It is possible to cancel subscription of a handset to a base. You should do this if a handset is
damaged and has to be replaced by a new one.
• Press the left ‘Menu’ key.
• Press the up or down key
/ repeatedly until ‘BS Settings’ is selected.
•Press ‘Select’ to confirm.
• Press the up or down key
/ repeatedly until ‘Terminate HS’ is selected.
•Press ‘Select’ to confirm.
• Enter the PIN code and press ‘OK’.
• Use the up or down key
/ to select the handset. If you select the current
handset or a non-existing handset, a warning tone will be heard.
•Press ‘Select’ to confirm your selection or press ‘Back’ to leave the menu.
13.3 Selecting a base unit
If your handset is subscribed to several base unit stations (max. 4), you must select a base
unit because the handset can only communicate with one base unit at a time.
• Press the left ‘Menu’ key.
• Press the up or down key
/ repeatedly until ‘HS Settings’ is selected.
•Press ‘Select’ to confirm.
• Press the up or down key repeatedly until ‘Select Base’ is selected.
•Press ‘Select’ to confirm.
• Use the up or down key
/ to select the base. If you select the current a non-
existing base, a warning tone will be heard.
• The display will show ‘Selected BSx’. Press the ‘Select’ key to confirm.
13.4 Using multiple handsets
13.4.1 Calling another handset
• Press the internal call key .
•‘Intercom 1 2 3 4 5” appears on the display.
• Dial the number of the handset you would like to call.
• After finishing your call, press the on hook key to hang up.
13.4.2 Receiving an internal call
• The internal call icon and the number of the handset calling, appear on the
display.
• Press the off hook key to accept the internal call.
OR
You can only cancel subscription of another handset, not the
handset you are using to do the remove procedure.
Caution: Before you can select a base unit, the handset must be
subscribed to the base first.
These functions are only possible when more than one handset is
subscribed to the base.
15
7
15
7
15
7
13
5
15
7
15
7
14
6
12