Topcom SOLOGIC B935 - Additional Handsets and Bases; Adding a New Handset

22 Sologic B935
Sologic B935
•Press ‘Reset’ to confirm your selection or press ‘Back’ to leave the menu without
saving.
The default settings are:
Dial Mode: Tone
Flash time: Flash-1
PIN Code: 0000
12.5 Storing a number under a photo key
You can store a number under each photo key of max. 32 digits. To store a number:
• Press the Memo key
• The display will show ‘- - - - - - - - - -’
• Enter the number (up to 32 digits).
• Press the Memo key again.
• Press the photo key.
13 Additional handsets and bases
You can subscribe up to 5 handsets on one base. Each handset can register to 4 base
stations and the user can select which base he wants to use. By default the handset 1 is
registered to the base unit 1.
13.1 Adding a new handset
Keep the paging key on the base unit pressed for 5 seconds. The base unit will stay
in subscribing mode for 3 minutes. Do the following to subscribe the handset:
• Press the left ‘Menu’ key.
• Press the up or down key
/ repeatedly until ‘Registration’ is selected.
•Press ‘Select’ to confirm.
• Press the up or down key
/ to select a base (1-4).
• The handset will now search for a base end when it’s found the system PIN code (base
PIN code; default=’0000’) is asked.
• Enter the PIN code and and press ‘Select’.
• The standby screen will appear when successfully registered and handset name and
number will be shown.
The numbers stored under each photo key will not be erased!
See “7.3.6 Calling a programmed number from the photo keys” how
to call these numbers.
This is only needed when you have deregistered a handset or when
you bought a new one.
Each handset can be subscribed to 4 different DECT base units. Each
base unit is assigned a number from ‘1’ to ‘4’ in the handset. When
you subscribe a new handset, you can assign a base unit number. It
is best to use ‘1’.
13
5
20
20
19
15
7
15
7