2031005680 Rev. C, 06/2016 7
5.9 System Programming Button
The System-programming button (P) is located on the control panel (see Figure 2).
This button is used to initialize the IS-5500 programming mode in which desired
environment settings can be stored into the IS-5500's memory for activation by one of the
system activators. The overhead lamp, room lights, and auxiliary receptacles 1 and 2 can be
programmed to change to a preset state when the appropriate activator is triggered.
The five (5) system activators are: each hand-held instrument charging well (total 3), the BIO
dimmer knob, and the slit lamp arm power button.
Follow the instructions in the following section to program any one of the IS-5500 system
activators.
5.9.1 Programming
1. With the system power ON, place the activator in its "normal" (non-use) position.
Press and hold the system programming button to enter programming mode, keep
holding until an audible tone is heard, and then release.
2. While in programming mode, 20 seconds are allotted to program each setting. A beep
will be heard each second during the 20-second window.
3. Using the Roomlight control, overhead lamp control, and AUX 1 or 2, which are all
located on the control panel (see Figure 2), adjust the environment lighting to the
desired settings.
4. When the desired settings are obtained, remove the appropriate hand-held from its
charging well, or turn the BIO ON, or press the slit lamp arm power button. A two-
toned beep will be heard to indicate that the setting has been recorded.
5. Place the activator back to its "normal" state and the environment will change back to
the settings before the programming sequence.
6. Programming is complete and will remain in memory until it is changed. Once
programmed, removing the appropriate hand-held from its charging well, or turning
the BIO ON, or pressing the slit lamp arm power button, will return the environment to
the preset condition.
7. Repeat the steps above for each activator.
5.9.2 Programming Reset
1. Switch the Stand Power off using the Power button on the control panel.
2. Press and hold down the Programming button, and then press and hold the Power
button for at least 3 seconds, until beeping sound is heard.
3. Release all buttons. The unit is now clear of all stored programming.
4. To re-program, follow steps in previous Programming Section.
To Next Page
Loading...