14
Operation
Scanning Mode
In scan mode, the laser rotates slowly, “searching” for the Magnetic Scanning Target. When the
target is properly placed in the beam path, the laser beam will scan rapidly back and forth on the
target and “track” the target as it is moved in its path.
1
To change to scanning mode when operating, press the mode switch control key (see
page 11).
2
To initiate target scanning, place the Magnetic Scanning Target in the beam path with the
reflective strips facing toward the laser.
3
To end target scanning and resume searching beam, remove target from beam path.
Face the target toward the instrument to start scanning.Set scanning mode
Horizontal rotation
Vertical rotation
To Next Page
Loading...
