49
BEFORE REQUESTING SERVICE
ERROR CODE LIST
When "Err " ( means an error number) is displayed in the blinking status on the con-
trol panel screen with a beep sound due to an operation error or a malfunction of the instru-
ment, correct the error according to the table below.
When any other error except "Err0", "Err2", "Err7", "Err9" and "Err11" is displayed, consult your
dealer.
Display Cause How to correct
Err0 The lamp house cover is opened. Close the lamp house cover firmly.
Err1 Overcharge or undercharge of charge
voltage.
Consult your dealer.
Err2 USB cable is not connected properly. Check the connection of the USB
connector.
Err3 FAG exciter filter does not work properly. Consult your dealer.
Err4 Nothing (Not used) Nothing (NA)
Err5 Photography aperture original point sensor
does not work properly.
Consult your dealer.
Err6 Barrier filter motor sensor does not work
properly.
Consult your dealer.
Err7 Angle sensor does not work properly. Operate the angle changing lever again.
Err8 The mirror and filter of the TV relay lens do
not work properly.
Consult your dealer.
Err9 Desired filter does not work properly. Operate the desired filter again.
Err10 Illumination aperture does not work properly. Consult your dealer.
Err11 Internal fixation target does not work
properly.
Move the internal fixation target to the
"OFF" side.
To Next Page
Loading...