Topeak FlashStand FAT - User Manual

GB
for 26" Mountain Bike
FlashStand FAT
User's Guide
* Maximum Weight Load: 20 kgs / 44 lbs
83˚~86˚
Adjust FlashStand FAT height to make sure your bike is within the
recommended angle of 83˚~86˚ (from horizontal plane) for stability
of your bike. Improper installation or lean angle may cause your
bike to fall and cause damage to it and/or FlashStand FAT.
IMPORTANT NOTES
80mm~ 180mm
(3.2"~7")
45mm (1.8")
60mm (2")
FlashStand FAT is designed to be used on bikes with crank-
arm width less than 45mm (1.8") at top 60mm (2") insert.
4mm
Allen Key
Support
Leg
If support legs on FlashStand FAT become loose, tighten its bolts
as shown. Do not over tighten the bolts as this may damage the
support legs.
FlashStand FAT is designed to be used on bikes with crank-
arm distance from the ground between 80mm and 180mm
(3.2"~7").
* Please read all instructions and caution notes carefully before use.

Summary

Important Notes

Crank Arm Width Compatibility

Ensures compatibility by checking crank-arm width is less than 45mm at 60mm insert.

Support Leg Maintenance

Tighten loose support leg bolts carefully to avoid damage. Do not overtighten.

Bike Stability Angle Adjustment

Adjust height for 83°~86° angle for stability. Improper angle may cause bike to fall.

Installation Guide

Cautions for Use

Product Warranty Information

Topeak FlashStand FAT Specifications

General

Brand	Topeak
Model	FlashStand FAT
Category	Bicycle Accessories
Language	English