Topeak NINJA C User Manual

HOW TO REMOVE NINJA C FROM HANDLEBAR
Periodically check that NINJA C is seated in
handlebar properly.
WARNING
PULL OUT
User's Guide
NINJA C
GB
HOW TO STORE NINJA C IN HANDLEBAR
LIMITATIONS
Handlebar with minimum 70 mm straight
section end
Fits inner ø 16.5-20 mm tube Fits grips with
end caps
MAINTENANCE
Loosen bolt and remove end cap of grip on both
sides. (Depends on the type of handlebar)
(Example for grips with end caps)
Turn the cap to expand the
rubber ring as little as necessary.
Press to adjust
the shape of
rubber ring as
shown.
Push NINJA C into the end
of handlebar on both sides.
If NINJA C does not fit properly into handlebar, adjust
tension of rubber ring as necessary and reinstall.
PUSH
Rubber Ring Chain Pin x 2
Compartment
• Fits Road handlebar with
minimum 70 mm straight
section end.
• Fits inner ø 16.5-20 mm tube.
• Fits multi-speed chains up to
Campagnolo® 11 speed hollow
pin chain.
• Please read these instructions
before first use.
Chain Hook
4 mm Allen Key
(Chain
Pin is not
included)
Adjusting Knob and
Chain Pin Breaker
• Lubricate and maintain tool with Teflon®
based lubricant as needed.
• To prevent rusting, keep tool dry.
1STEP 2STEP 3STEP
Cap
Rivet Anvil
of hollow pin
1 2 3
ø 16.5 mm
ø 20 mm
ROAD HANDLEBARS FLAT BARS
70 mm
70 mm

Topeak NINJA C Specifications

General

Type	Chain tensioner
Product color	Black, Stainless steel
Surface coloration	Monochromatic
Quick start guide	Yes

Weight and Dimensions

Depth	86 mm
Width	23 mm
Weight	77 g