Need help?Do you have a question about the Topten TK108 and is the answer not in the manual?
Program the tracker to send alarm SMS to authorized mobile numbers.
Arm or disarm the system by calling the tracker's SIM card number.
Inquire vehicle location and system status using SMS command.
Arm or disarm the system and stop alerts using specific SMS commands.
Receive a Google Maps URL via SMS to view the vehicle's location.
Get the car's real physical address (city, street) via SMS.
Change the default user password using an SMS command.
Immediately stop the car by sending a specific SMS command.
Restore the car to normal operation after it was stopped via SMS.
Listen to the audio around the vehicle using SMS commands.
Read and set the vehicle's odometer value using SMS commands.
Configure and receive alerts when the vehicle exceeds a set speed limit.
Upgrade the device firmware over-the-air using SMS commands.
Configure different power saving modes for the device.
Configure the device to automatically take photos at set time intervals.
List of additional SMS commands for various functions like movement alarm and sensor settings.
Optimize location sampling based on vehicle turning angle.
Check the vehicle's external power battery voltage.
Set the time interval for the device's heartbeat data packets.
View the current GPRS configuration settings of the device.
Retrieve firmware version, IMEI, and other device information.
Configure the device to connect to an alcohol sensor or SOS button.
Triggered when the car is vibrated while in arming status.
Triggered when the car battery is cut off or low in arming/disarm status.
Triggered when the car's engine is turned ON in arming status.
Triggered when the car moves away from its parking point by 100 meters.
Triggered by sudden speed-up or harsh braking of the vehicle.
Triggered if the car exceeds the speed limit for 3 minutes.
Triggered when the SOS button is pressed.
Description of the RFID reader module and its placement.
Details on RFID tag operation, ID, and battery life.
Use SMS commands to activate or deactivate the RFID function.
Enable or disable the arm/disarm function using authorized RFID tags.
Authorize up to 20 RFID tags to arm or disarm the system.
To Next Page
General
