PROGRAMMING YOUR E101B / E103B / E120B
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN
MODE AND THEN PRESS EVENT TO UPDATE
THE LOAD STATUS.
AT POWER UP:
When powering up the unit for the first time,
12:00 will flash on the display. NOTE: Allow 1-2
minutes for the supercap to charge before any
display is shown.
Press the MODE key to go to the CLK mode. After
pressing the MODE key the display will show:
1.0 TO SET CLOCK
Press HOUR and MIN to advance to the present
hour and mins. Check AM/PM, and press ENTER.
1.1 TO MODIFY CLOCK
Press MODE until the display shows: CLK. Press
HOUR and MIN. to modify clock and press
ENTER.
2.0 TO SET DATE
If you are setting for the first time, display will
show:
3
To Next Page
Loading...
