Tormax iMotion 1401 User Manual

8 Instructions for Use TORMAX iMotion 1301/1301.S / 1302.KI /1401 T-1305 en
2.7 Decommissioning the System in the Event of a Fault
If there is a fault the automatic swing door may only be taken out of service by a skilled person, the
operator or a person who is instructed to do so by the operator. This must be done on all occasions on
which the safety of persons could be compromised.
• Disconnect the door system from the power supply. All the poles are disconnected using a 3-pole
IEC-plug or another all-pole disconnection device (e.g. in the fuse box).
• If another power source (e.g. battery u) is available, it must be disconnected from the system by a
specialist.
• Open the door manually and fix it open if it is installed in an escape route.
See chapter 6 and 8 for rectification of faults.
2.8 Disposal
This system must be properly dismantled at the end of its working life. Its disposal must comply with
national regulations. We recommend that you contact a skilled person disposal company.
Warning
Electric voltage
Risk of injury by electric shock
• Disconnect the mains power supply to the installation before dismantling.
Warning
Aggressive acids
Risk of injury if you dismantle the battery module.
• Dispose of batteries properly.
Warning
Flying around parts
The tensioned spring represents a hazard when dismantling the drive.
• The drives may only be dismantled and prepared for proper disposal by a competent
person.
Warning
Broken glass
Risk of injury when dismantling the door leaves.
• Take care when transporting the door leaves.

Tormax iMotion 1401 Specifications

General

Brand	Tormax
Model	iMotion 1401
Category	Door Opening System
Language	English