Instructions for Use iMotion 2202 / 2301/ 2302 / 2401 T-1321 e 5
2 Safety
2.1 Responsibilities
For instructing the operator: A specialist from a TORMAX sales partner
For operating the system: The operator or a person instructed by the operator
For maintenance and function control: The operator or a person instructed by the operator
For annual testing and approval: A specialist authorised by the manufacturer
Specialists are persons who have adequate knowledge in the field of power-operated doors as a result
of their specialist training and experience and who are so familiar with the relevant health and safety
regulations, guide-lines and generally recognised codes of practice that they are able to assess the
condition of power-operated doors with regard to the safety of their operation.
Maintenance of electrical parts must be carried out by a trained electrician.
2.2 Use for the Purpose Intended
The automatic sliding door is intended exclusively for use in dry premises in areas used as a pedes-
trian thoroughfare. The manufacturer will not accept any liability whatsoever for loss or damage caused
by improper use, failure to comply with the maintenance specification (see section 6) or unauthorised
modification of the system.
2.3 Pre-conditions for the Operation of the System
The door system was designed, installed and checked for functionality and safety by specialists prior
to hand-over to the operator. The company responsible for the system’s installation instructed the op-
erator on the system’s use and maintenance as well dangers associated with the system operation.
The operator has confirmed this by his signature in the system test book T-879.
The provisions imposed by law, health and safety and occupational health regulations for the avoidance
of accidents and the protection of the environment which are generally applicable in the country in
which the system is operated supplement the instructions for use.
• Readtheinstructionsforusecarefullybeforecommissioningtheautomaticslidingdoor.
• Onlyusethesystemwhenitisinperfectworkingorder.Theoperatingconditions,inspection
and maintenance intervals stipulated by the manufacturer must be observed (section 6).
• Safetyfacilities(e.g.sensortechnology,manualunlocking)mustnotberemovedordisabled.
• Arrangetohaveanyfaultsrectiedimmediatelybyaspecialist.
2.4 Hazards and Risks
Depending on the system design and equipment, there is a residual risk of crushing, entanglement and
collision in the movement area of the door leaves – albeit with restricted force.
To Next Page
Loading...
Need help?
General
