To Next PageTo Next Page
Need help?Do you have a question about the Tormax iMotion 1401 and is the answer not in the manual?
Crucial safety information for system operation and compliance.
Product designed for automatic swing doors in dry environments.
Installation, maintenance, and repair must be done by a qualified person.
Operation by trained persons following instructions is mandatory.
Manufacturer not liable for damage from improper use or modification.
System designed, installed, and checked by specialists before handover.
Operator must be instructed and confirm use in the system test book.
Responsible staff must read and understand instructions before use.
Use system only in perfect working order and observe maintenance intervals.
Arrange immediate rectification of any faults by a specialist.
Risks of crushing, shearing, and collision with limited force.
Risks at closing edges, linkage lever, and near moving parts.
Risks from damage, incorrect installation, or defective sensors.
Risk of injury; ensure system is repaired by a qualified person.
Regular checks and examinations must be carried out as instructed.
System removal from service by skilled person, operator, or instructed person.
Disconnect all poles from the power supply for service.
Disconnect battery units by a specialist.
Risk of electric shock; disconnect power before dismantling.
Risk of injury from battery module acids; dispose batteries properly.
Hazard from tensioned spring; professional dismantling required.
Risk of injury from door leaves; exercise care during transport.
Ensuring free accessibility and clear swing area of the door.
Automatic opening and closing triggered by sensors.
Safety sensors prevent impact; switches to safety/emergency mode.
Minimizes impact and crushing hazards via speed and force limits.
Details OFF, AUTOMATIC 1, AUTOMATIC 2, EXIT, OPEN, and Manual Operation modes.
Instructions for using the interface for modes and unit unlocking.
Browsing and resetting faults using the TORMAX user interface.
Risk of limb entrapment; disconnect power before maintenance.
Checking function and safety devices at least every 3 months.
Hazards from malfunction; secure area during checks.
Lists system behavior, causes, and remedies for common faults.
Procedures and expected results for checking sensors and components.
General| Control System | Microprocessor-controlled |
|---|---|
| Power Consumption | 150 W |
| Protection Class | IP 20 |
| Operating Temperature | -20°C to +50°C |
| Max. Current Consumption | 1.5 A |
| Type | Door Operator |
| Power Supply | 230V AC, 50Hz |
| Max Door Leaf Width (double leaf) | 1200 mm |
| Opening Speed | 0.1 - 0.7 m/s (adjustable) |
| Hold-open Time | 0 - 60 s (adjustable) |
