Tornado 99772 - Programmed Maintenance Schedule; Recommended Brushes and Pads

22
INTERVENTION
DAILY 20 HOURS * 200 HOURS * 1000 HOURS *
RECOVERY TANK CLEANING
•
SUCTION FILTER CLEANING
•
SOLUTION TANK FILTER CLEANING
•
BRUSH CLEANING
•
BRUSH DISASSEMBLY AND CLEANING
•
SQUEEGEE CLEANING
•
FRONT SQUEEGEE RUBBER REPLACEMENT
•
REAR SQUEEGEE RUBBER REPLACEMENT
•
SPLASH GUARD RUBBER REPLACEMENT
•
CHECK SQUEEGEE ADJUSTMENT
•
SQUEEGEE HOSE CLEANING
•
SOLUTION TANK CLEANING
•
CHECK BATTERIES ELECTROLYTE
•
TRACTION MOTOR CHECK
•
BRUSH MOTOR CHECK
•
SUCTION MOTOR CHECK
•
CHECK BRUSH BASE GROUP
•
SCREW TIGHTENING
•
PROGRAMMED MAINTENANCE
* The hours refer to the ones indicated on the display (see under paragraph ”HOUR METER”).
MATERIAL CHARACTERISTICS
PPL (Polypropylene) Good wear resistance. Maintains characteristics with hot water up to 50°C. It is not hygro-
scopic.
NYLON Excellent wear resistance, even with hot water. It is hygroscopic.
TYNEX Nylon bristles with grains of abrasive material. Use with caution in order not to mark the
oor or ruin the polishing.
BRISTLES THICKNESS Thicker bristles are more rigid and must be used on smooth oor or oor with small joints.
On irregular oors with deep joints or relieves, it is recommended to use softer bristles
which penetrate more easily and deeper. Please be aware that when brush bristles are
worn out and therefore too small, they become rigid and unable to penetrate and clean
deeper. This may also happen with thicker bristles creating brush vibration.
PAD HOLDER It is equipped with anchor points which permit the blocking of the abrasive pad during work.
The pad is recommended to clean smooth oors.
MACHINE CODE QUANTITY DESCRIPTION USE
BD 26/27 48903020 2 Brush PPL 0,6 Ø 345 Normal oors.
48903030 2 Brush PPL 0,9 Ø 345 Smooth oors with small joints and persistent dirt.
48903040 2 Brush TYNEX Ø 345 Floors of resistant material and particularly dirty.
48903050 2 Brush 5-mix Ø 345 For all types of oors.
48803010 2 Pad holder Ø 330 For pads of 14”, for smooth surfaces cleaning.
48803030 2 Pad holder Ø 330 + center
lock green
For pads of 14”, for smooth surfaces cleaning.
48803040 2 Pad holder Ø 330 + center
lock black
For pads of 14”, for smooth surfaces cleaning.
RECOMMENDED BRUSHES
Brushes must be chosen depending on type of oor and dirt to be removed. The employed material and the bristles diam-
eter are the elements that distinguish different types of brushes.
https://harrissupplyind.com - To Order Parts Call 608-268-8080