EasyManuals Logo

Tornado H920 User Manual

Tornado H920
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
INSTALLING THE GB603 GIMBAL AND CAMERA
FOR THE GH4 CAMERA
STEP 1) Install the Fastening Block to the camera's flash mount.
STEP 2) Plug the HDMI cable into the camera.
STEP 3) Place the Camera Mount with lens frame downward, and fit the GH4 camera
with its lens downward.
NOTICE: Make sure the Camera Battery is fully charged
and the SD card is free of space.
STEP 4) Secure the screw on the top and at the bottom
of the frame to fix the camera on the Camera Mount.
STEP 5) Insert the HDMI cable in the corresponding
port on the camera (the right side of GH4) after
connecting the Shutter cable in the port at the top
left side of the camera through the frame.
NOTICE: It requires securing the fastening screws of
camera lens if the GB603 is with a SONY a7 lens mount frame.
IMPORTANT NOTE: Make sure the white plug (or with LK58 logo) connected to the
port of LK58, and the black one (or with camera logo) is connected to the
camera.When installing the GB603 camera gimbal on the H920 copter, replace the
normal antenna with the mushroom antenna.
Connect the GB603 gimbal to the damping plate on the
H920 by turning the 4 fastening screws in a clockwise
direction, tighten them until they feel secure.
NOTICE: Be sure to mount the GB603 correctly by
positioning the label "FRONT" located on the Yaw/Top
Motor toward the Front of the Aircraft.
18
FOR THE SONY α7 CAMERA
STEP 1) Replace the GH4 camera lens mount
frame with SONY α7 lens mount frame, and
secure the 10 screws on the top and bottom
of the frame to fix the frame.
STEP 2) Install the infrared ray mount device
to the left side of the SONY α7 lens mount
frame, secure the screw on the bottom of the
device, and connect the white connector to
the IR port
STEP 3) Mount the SONY α7CG balancer on
the GB603 as illustrated.
STEP 1
STEP 2STEP 3
STEP 4) Install the SONY® α7 camera on the camera mount, there is no need to
connect shutter cable for SONY® α7
NOTICE: If using GB603 camera gimbal without SONY® α7 lens mount frame, only
GH4 camera can be mounted. If using GB603 camera gimbal with SONY® α7 lens
mount frame, both GH4 and SONY® α7 cameras can be mounted.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tornado H920 and is the answer not in the manual?

Tornado H920 Specifications

General IconGeneral
BrandTornado
ModelH920
CategoryDrones
LanguageEnglish