Toro 03691 - Adjusting the Control Arm Position; Installing the Cutting Units

Figure2
1.Step2.Stepbrackets
2.Raiseorlowerthesteptothedesiredheightand
re-securethebracketstotheframewiththe2bolts
andnuts.
3.Repeattheprocedureontheotherstep.
3
AdjustingtheControlArm
Position
NoPartsRequired
Procedure
Thecontrolarmpositioncanbeadjustedforthe
operatorscomfort.
1.Loosenthe2boltssecuringthecontrolarmtothe
retainingbracket(Figure3).
Figure3
1.Controlarm3.Bolts(2)
2.Retainingbrackets
2.Rotatethecontrolarmtothedesiredpositionand
tightenthe2bolts.
4
InstallingtheCuttingUnits
Partsneededforthisprocedure:
1Fronthoseguide-R.H.
1Fronthoseguide-L.H.
Procedure
1.Removethereelmotorsfromtheshippingbrackets.
2.Removetheshippingbracketsanddiscard.
3.Removethecuttingunitsfromthecartons.Assemble
andadjustasdescribedinthecuttingunitOperator’s
Manual.
4.Makesurethecounterweight(Figure4)isinstalled
totheproperendofthecuttingunitasdescribedin
thecuttingunitOperator’sManual.
13