19
Lubricating the Machine
The machine has 3 grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
Lubricate the front wheel bearing (Sand Pro 3020 only) and
traction control linkage after every 25 hours of operation.
Lubricate the steering shaft every 100 hours.
Lubricate the following bearings and bushings:
• Front wheel bearing (Fig. 14) (Sand Pro 3020 only)
• Traction control linkage (Fig. 15)
• Steering shaft and sprocket (Fig. 16)
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
Figure 14
Figure 15
Figure 16
Note: Do not lubricate the steering chain unless it becomes
stiff because of rust. If the chain rusts, it may be lubricated
lightly with a dry-type lubricant.
Changing the Engine Oil and
Filter
Change the oil initially after the first 8 hours of operation;
thereafter change the oil every 25 hours and the filter every
100 hours.
1. Park the machine on a level surface and turn the engine
off.
2. Remove the drain plug (Fig. 17) and let oil flow into a
drain pan. When the oil stops, install the drain plug.
3. Remove the oil filter (Fig. 17). Apply a light coat of
clean oil to the new filter gasket.
1
2
Figure 17
1. Drain plug 2. Oil filter
To Next Page
Loading...
