9
Installing the Wheels
Note: Install the rear wheels to the machine while it is still
on the pallet shipping blocks.
1. Mount a wheel to each wheel motor and secure them
with the lug nuts. Tighten the lugs nuts evenly and
gradually in a crisscross manner to 45–55 ft.-lb.
(61–75 N⋅m).
2. Remove the banding securing the machine to the pallet.
3. Place a jack under the square tube of the frame (Fig. 1).
1
Figure 1
1. Tubular frame
Note: For removal of the shipping blocks, place the jack
only under the tubular frame. Do not place the jack under
the wheel motors, or damage could result.
4. Jack up the machine, remove the shipping blocks, and
lower the machine onto the rear wheels.
Note: We suggest saving the shipping blocks, as they are
the correct height for blocking the unit when changing the
tires, servicing the wheel motors, or performing other
service work.
Installing the Steering Wheel
1. Move the front wheel so that it points straight ahead.
2. Slide the steering wheel onto the steering shaft, aligning
the mounting holes.
3. Secure the steering wheel in place with the roll pin
(Fig. 2).
1
2
Figure 2
1. Steering wheel 2. Roll pin
Mounting the Seat
1. Secure the seat to the seat plate with 4 capscrews (5/16
x 5/8 in.) (Fig. 3).
1
2
Figure 3
1. Seat 2. Seat plate
2. Move the lever on the right side of the seat outward,
slide the seat to the desired position, and release the
lever to lock the seat into position.
To Next Page
Loading...
