7
Specifications
General Specifications
Configuration
Short wheel base tricycle vehicle with mid engine placement. Front wheels
powered on 2020 and all wheels powered on 3020. Front wheel steering. Operator
positioned centrally.
Engine
Briggs & Stratton, V-twin cylinder, 4 cycle, OHV, air cooled, gas engine with cast
iron sleeves. 16 hp @ 3600 RPM, 29.3 cu. in. (480 cc) displacement, 1-3/4 US qt.
(1.66 l) oil capacity. Electronic ignition. Full pressure lubrication, oil filter. Engine
and remote mounted air cleaners.
Instrumentation Hour meter
Gas Tank 4-1/4 gallon (16.1 l) capacity
Battery 12 volt, lead acid, 32 amp. hour
Drive
Hydraulic. Coupling driven variable displacement piston pump with integral auxiliary
charge pump to geroller motors which directly drive wheels.
Hydraulic Oil Filter 25 micron, spin-on type
Hydraulic Oil Reservoir 3 gallon (11.4 l) capacity
Valve Single section for raising and lowering of implement with float
Cylinder Double acting
Wheel Bearings Needle bearing in each wheel motor
Tires
22 x 11.00-8 two-ply pneumatic tubeless. De-mountable and interchangeable.
Recommended tire pressure is 4–6 psi (28–41 kPa).
Speeds (at 3200 RPM)
Variable between 0 and 9 MPH (0 and 14 km/h) forward and 0 and 4 MPH (0 and
6 km/h) reverse
Seat Adjustment 4 inches (10.2 cm) fore and aft.
Measurements
Width without implement 57-1/2 in. (146 cm)
Width with rake Model No.
08812
75 in. (191 cm)
Height 45 in. (114 cm)
Length without rake 76 in. (193 cm)
Net weight (wet)
Sand Pro 2020
Sand Pro 3020
650 lb.( 295 kg)
700 lb. (318 kg)
To Next Page
Loading...
