Adjusting the Cutting Height
Adjusting the cutting height may bring y ou into contact with the mo ving blade, causing serious injur y .
• Stop the engine and w ait f or all mo ving par ts to stop .
• Do not put y our finger s under the housing when adjusting the cutting height.
If the engine has been r unning , the muf fler will be hot and can sev er el y bur n y ou. K eep a w ay fr om the hot
muf fler .
Adjust the cutting height as desired. Set all four wheels to the same height.
Note: Only a front cutting height lev er is sho wn.
Figure 11
Adjusting the Handle Height
Squeeze the bottom of the handle halv es tog ether and
c hang e the handle holes in whic h the pins are mounted,
as sho wn in Figure 12 .
Figure 12
1. Pin
3. Use this hole to lower the
handle
2. Use this hole to raise the
handle
6
To Next Page
Loading...
