Toro 20382 - Adjusting the Cutting Height; Adjusting the Handle Height; Starting the Engine

AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.Setallfourwheelsto
thesameheight.
Note:Toraisethemachine,moveall4cuttingheightlevers
forward;tolowerthemachine,movethemallrearward
(Figure11).
G017462
Figure11
AdjustingtheHandleHeight
Youmayraiseorlowerthehandletoapositioncomfortable
foryou.
Rotatethehandlelock,movethehandleto1of3positions,
andlockthehandleintoposition(Figure12).
Figure12
1.Handlelock2.Handlepositions
StartingtheEngine
1.Pulltheblade-controlbartothehandle(Figure13).
Figure13
2.Pulltherecoilstarthandle(Figure14).
Figure14
9