31
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the fuel
tanks; refer to Draining Fuel Tanks, page 30.
D. Start the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it will not start again.
G. Dispose of fuel properly. Recycle as per local
codes.
Important Do not store stabilizer/conditioned gasoline
over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the traction unit in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place.
16. Cover the traction unit to protect it and keep it clean.
Important When removing the traction unit from
storage, charge the battery; refer to the Setup section.
Troubleshooting
Problem Possible Causes Corrective Action
Starter does not crank
1. Auxiliary hydraulics lever is not
in neutral position.
1. Move lever to neutral position.
2. Battery is dead. 2. Charge the battery.
3. Electrical connections are
corroded or loose.
3. Check electrical connections
for good contact.
4. Relay or switch is defective. 4. Contact Authorized Service
Dealer.
Engine will not start, starts hard, or
1. Fuel tanks are empty. 1. Fill fuel tanks with gasoline.
fails to keep running.
2. Choke is not on. 2. Move choke lever fully forward.
3. The fuel valve is closed. 3. Open the fuel valve.
4. Air cleaner is dirty. 4. Clean or replace air cleaner
element.
5. Spark plug wires are loose or
disconnected.
5. Install wires on spark plugs.
6. Spark plugs are pitted, fouled,
or gap is incorrect.
6. Install new, correctly gapped
spark plugs.
7. Dirt in fuel filter. 7. Replace fuel filter.
8. Dirt, water, or stale fuel is in
fuel system.
8. Contact Authorized Service
Dealer.
To Next Page
Loading...
