5
Specifications
General Specifications
Brush Filament Material Virgin polypropylene, high carbon wire or combination of both.
Brush Diameter Uses 24 inch brush elements.
Oscillation Angle 8 degrees.
Sweeping Width Angle
Brush swings 25 degrees in both directions. 70.5 inches sweeping width @ center
position, 64 inches minimum sweeping width @ full swing left or right.
Castor Wheels Two 8.0 inch x 3.5 inch pneumatic rubber tires
Ground Clearance 6 inch
Brush Speed
220 rpm, no load for Groundsmaster 4000.
240 rpm, no load for Groundsmaster 4100
Brush Ground Pressure
Adjustment
Adjustment is with .5 inch spacers and holes in castor fork.
Hydraulic/Mechanical
Brush Drive
6.10 cubic inch roller vane motor drives directly into 16 tooth sprocket. A 40 tooth
sprocket is mounted on brush shaft. One #60 chain connects motor and brush.
Brush Swing/Control
A 2 inch bore, 15 inch stroke, swing cylinder is connected in parallel with hydraulic
brush drive. The cylinder is controlled by 3–position, closed center, 4–way solenoid
directional valve. A 6 mm grade 8.8 shear bolt connects rod end of cylinder to
4–bar linkage.
Electrical Connection
Wire Harness Kit, Part No.110–3263 is required for traction unit model numbers
30410 and 30411 or Part No. 115–8492 for models numbers 30412 and 30412 .
Order the appropriate kit from your Local Toro Distributor.
Weight 642 lbs.
Note: Specifications and design subject to change without notice.
Optional Equipment
High carbon wire brush filament Part No. 95–5942
To Next Page
Loading...
