Why is hydraulic oil foaming in my Toro 30426 Lawn Mower reservoir?
If hydraulic oil in the reservoir of your Toro Lawn Mower foams, it could be due to a low hydraulic reservoir oil level, the wrong type of oil in the hydraulic system, or air leaking into a pump suction line. Maintain the proper hydraulic reservoir oil level, use the correct type of hydraulic oil, and check for air leaks in the pump suction line.
Why is the steering on my Toro 30426 Lawn Mower inoperative?
If the steering on your Toro Lawn Mower is inoperative or sluggish, it could be caused by worn or binding steering components (like tie rods or steering cylinder ends), a binding steering cylinder, a low oil level in the hydraulic reservoir, a stuck or damaged steering relief valve in the steering control valve, internal leaks in the steering cylinder, a worn or damaged steering control valve, or a worn or damaged gear pump section. Inspect and repair or replace any worn or binding steering components. Maintain the correct hydraulic oil level. Repair or replace the steering relief valve if it's stuck or damaged. Inspect the steering cylinder, control valve, and gear pump section for any damage.
General| Engine Type | 4-Cycle |
|---|---|
| Drive Type | Hydrostatic |
| Cutting Height Positions | 7 |
| Cutting Height | 1.5 - 4.5 inches |
| Fuel Tank Capacity | 3 gallons |
| Warranty | 2 years limited |
| Engine | Briggs & Stratton 550E Series |
To Next Page
