20
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
The use of protective equipment, such as but not limited to,
for eyes, ears, feet, and head is recommended.
This machine produces sound levels in excess of
85dBA at the operator’s ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
Caution
1
2
Figure 12
1. Caution 2. Wear hearing protection
Controls
Seat
Pull seat adjusting lever (right side) (Fig. 13) outward, slide
seat fore or aft to desired position, and release lever to lock
seat in position. Seat moves 5.9 in. (15 cm) fore and aft in
19/32 in. (15 mm) increments. Knob at lower center
provides infinitely variable weight adjustment from
110–285 lb. (49.9–129.3 kg).
Figure 13
1. Seat adjusting lever
2. Weight adjusting knob
3. Weight indicator
Seat height adjusts vertically to three positions. To raise, lift
seat to first or second click stop; to lower, lift seat to
highest position, then lower to lowest position. Arm rests
pivot up and down.
Warning Light Check Switch
Before beginning operation, press the warning light switch
button (Fig. 14). All lights on control panel should light. If
a light fails to illuminate, there is an electrical malfunction
requiring immediate repair.
1
2 3
4
5
6
7
8
Figure 14
1. Coolant temperature
gauge
2. Fuel gauge
3. Hour meter
4. Coolant temperature
warning
5. Engine oil pressure
warning
6. No charge warning
7. Fuel system warning
8. Warning light check
switch
Engine Oil Pressure Warning
Dangerously low engine oil pressure is indicated by both a
warning indicator light (Fig. 14) and audible signal. When
this occurs, stop the engine immediately to keep possible
engine damage minimal.
No Charge Warning
No charge to the batteries is indicated by a warning
indicator light (Fig. 14) and audible signal.
Fuel System Warning
A warning indicator light (Fig. 14) and audible signal warn
of water in the fuel and need for service.
To Next Page
Loading...
