Toro 30674 - Adjusting the Handle Height

2.Stoptheengineandwaitforallmovingpartstostop
beforeleavingtheoperatingposition.
3.Loosen,butdonotremove,the2axlepivotboltsand
the2axleadjustmentbolts(Figure18).
Figure18
1.Axlepivotbolt2.Axleadjustmentbolt
4.Placeajackundertherearcenteroftheengineframe.
Raisethebackendoftheengineframeupenoughto
removethefront2axleadjustmentbolts(Figure18).
Note:Usejackstandstosupportthemachine.
5.Raiseorlowertheengineframewiththejacksothat
youcaninstallthefront2axleadjustmentboltsinthe
desiredholelocation(Figure18).
Note:Useataperedpunchtohelpaligntheholes.
6.Tightenall4boltsandlowerthemower.
7.Adjustthecontrolrodsandthebrakelinkagesas
required.RefertoServicingtheBrakesandAdjusting
theControlRods.
Important:Youmustadjustthecontrolrods
andthebrakelinkagewhenyouchangetheaxle
positionsforpropertractionandbrakefunction.
AdjustingtheCasterPosition
1.UsingtheHeight-of-CutChart,adjustthecaster
spacerstomatchwiththeaxleholeselected(Figure19).
Figure19
1.Latchpin
3.Spacer,13mm(1/2inch)
2.Spacer,5mm(3/16inch)
2.Removethelatchpin,slidethecasterfromthesupport,
andchangethespacers(Figure19).
3.Installthecasterinthesupportandinsertthevpin
(Figure19).
AdjustingtheHandleHeight
Thehandlepositioncanbeadjustedtomatchtheoperator's
heightpreference.
1.Removehairpincotter,washerandclevispinsecuring
controlrodttingtoidlerbracket(
Figure20).
Figure20
1.Controlrod4.Clevispin
2.Controlrodtting
5.Washer
3.Idlerbracket6.Hairpincotterpin
2.Loosentheupperangebolts(3/8x1inch)andange
nutsecuringhandletorearframe(Figure21).
20