Toro 37781 - Adjusting the Discharge-Chute Latch; Replacing the Drive Belts

Figure45
1.0.76mm(0.030inch)
5.Installthenewsparkplug,tightenitrmly,andattach
theignitionwiretothesparkplug.
Note:Ensurethattheignitionwiresnapscompletely
intoplaceonthesparkplug.
AdjustingtheDischarge-Chute
Latch
Ifthedischargechutedoesnotlockintothedesiredposition
ordoesnotunlocksothatyoucanmoveittoanother
position,adjustthedischarge-chutelatch.
1.Loosentheclampfasteneronthechute-supportplate
untilthecableisfree.
g019021
1
2
3
Figure46
1.Cableconduit3.Clampfastener
2.Cableclamp
2.Removeanyslackinthecablebypullingthecable
conduitrearward.
3.Tightentheclampfastenerwhileholdingthecablein
place.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetraction-drivebelt
becomesworn,oil-soaked,orotherwisedamaged,havean
AuthorizedServiceDealerreplacethebelt.
23