Toro 38066 - Installing the Handle Assembly; Handle Assembly; Bolts; Curved Washers

9
DESCRIPTION USEQTY.
Worm gear 1
Bracket 1
Carriage bolt 1 Installing the chute control gear
Flat washer 1
Locknut 1
Skids 2
Flange-head bolts—3/4 in. (1.9 cm) 2 Installing the skids
Flat washers and locknuts 2
Ignition key 1 Starting and stopping the engine
Installing the Handle Assembly
1. Remove the tie straps that secure the control rods to the
handle assembly.
2. Remove the axle pins from both wheels (Fig. 3) and
slide the wheels outward on the axle approximately one
inch (2.5 centimeters).
1
2
3
653
Figure 3
1. Axle pin (2)
2. Bolts and curved
washers (4)
3. Handle assembly
3. Hold the left side of the handle assembly in the
installation position and insert the upper traction rod
through the loop in the lower traction rod (Fig. 4).
1
m-2669
2
Figure 4
1. Lower traction rod 2. Upper traction rod
Important Ensure that the chute control rod
assembly is between the engine and the traction rod
(Fig. 5).