8
Assembly
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
DESCRIPTION QTY. USE
Flange-head bolts—3/4 in. (1.9 cm) 6
Lower belt cover 1
Installing the auger/impeller housing
Flange-head bolts—1/2 in. (1.3 cm) 5
Installing the auger/impeller housing
Cable cover 1
Shift rod 1
Locknuts 2
Installing the shift rod
Discharge chute 1 Installing the discharge chute
Worm gear 1
Gear bracket 1
Carriage bolt 1 Installing the chute control gear
Flat washer 1
Locknut 1
Skids 2
Flange-head bolts—3/4 in. (1.9 cm) 2
Flat washers 2
Installing the skids
Locknuts 3
Ignition key 1 Starting and stopping the engine
Installing the Auger/Impeller
Housing
1. Remove the 2 flange-head bolts that secure the idler
pulley assembly to the engine frame, and remove the
idler pulley assembly (Fig. 2).
163
5
2
3
4
1
Figure 2
1. Idler pulley assembly
2. Flange-head bolts
3. Impeller pulley
4. Engine frame
5. Auger housing
Important Remove the idler pulley assembly to
prevent damaging it.
To Next Page
Loading...
