2003—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Printed in the USA
All Rights Reserved
Original Instructions (EN)
Register your product at www.Toro.com
826LE Power Max Snowthrower
Model No. 38620—Serial No. 240000001 and Up
Form No. 3329-770 Rev A
Operator’s Manual
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the numbers
in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
• Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
• Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
• Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses 2 other words to highlight
information. Important calls attention to special
mechanical information and Note: emphasizes
general information worthy of special attention.
Warning
California
Proposition 65 Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
This spark ignition system complies with Canadian
ICES-002.
The enclosed Engine Owner’s Manual is supplied
for information regarding The U.S. Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission
systems, maintenance and warranty.
Keep this engine Owner’s Manual with your unit.
Should this engine Owner’s Manual become
damaged or illegible, replace immediately.
Replacements may be ordered through the
engine manufacturer.
Safety
This snowthrower meets or exceeds the B71.3
specifications of the American National
Standards Institute in effect at the time of
production.
Read and understand the contents of this manual
before the engine is ever started.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
to avoid possible injury or death.
Improperly using or maintaining this
snowthrower could result in injury or death. To
reduce this potential, comply with the following
safety instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.3–1995 and the ISO
8437:1989 standard.
To Next Page
General
