Toro 38622 User Manual

Form No. 3353-595 Rev A
Power Max™ 826LE Snowthrower
Model No. 38622 —Serial No. 260000001 and Up
Operator's Manual
Introduction
R ead this infor mation carefully to lear n ho w to operate and
maintain y our product properly and to a v oid injur y and
product damag e . Y ou are responsible for operating the
product properly and safely .
Y ou ma y contact T oro directly at www .T oro .com for
product and accessor y infor mation, help finding a dealer ,
or to register y our product.
W henev er y ou need ser vice , g en uine T oro par ts , or
additional infor mation, contact an A uthorized Ser vice
Dealer or T oro Customer Ser vice and ha v e the model and
serial n umbers of y our product ready . Figure 1 identifies the
location of the model and serial n umbers on the product.
W rite the n umbers in the space pro vided.
Figure 1
1. Model and serial number location
Model No.
Serial No.
T his man ual identifies potential hazards and has safety
messag es identified b y the safety aler t symbol ( Figure 2 ),
whic h signals a hazard that ma y cause serious injur y or
death if y ou do not follo w the recommended precautions .
Figure 2
1. Safety alert symbol
T his man ual uses 2 other w ords to highlight infor mation.
Impor tant calls attention to special mec hanical infor mation
and Note emphasizes g eneral infor mation w or th y of special
attention.
Warning
CALIFORNIA
Pr oposition 65 W ar ning
T he engine exhaust fr om this pr oduct contains
chemicals kno wn to the State of Calif or nia to cause
cancer , bir th defects, or other r epr oducti v e har m.
T his spark ignition system complies with Canadian
ICES-002
T he enclosed Engine Owner’ s Man ual is supplied
f or inf or mation r egarding the US En vir onmental
Pr otection Agency (EP A) and the Calif or nia Emission
Contr ol R egulation of emission systems, maintenance,
and w ar ranty . R eplacements may be order ed thr ough
the engine man uf actur er .
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved

Toro 38622 Specifications

General

Power Source	Gasoline
Clearing Width	21 in
Clearing Depth	12 in
Throw Distance	Up to 35 ft
Intake Height	12 in
Starter	Recoil
Warranty	2 years

Summary

Safety Information

Before Operating Guidelines

Pre-Operation Preparation Steps

Toro Snowthrower Specific Safety

Contains safety information specific to Toro products and general safety knowledge.

Operation and Maintenance

General Operation Guidelines

Setup and Assembly

Installation Steps

Installing the Upper Handle

Instructions for lifting, positioning, and securing the upper handle assembly.

Installing the Traction Control Linkage

Steps to connect the speed control rod to the lower link arm and speed selector lever.

Installing the Chute Control Rod

Instructions for routing and connecting the chute control rod using the Quick Stick.

Connecting Headlight Wire

Pre-Operation Checks and Filling

Filling the Engine with Oil

Instructions for checking and adding engine oil, including oil type and capacity.

Product Overview and Operation Modes

Freewheeling vs. Self-Propel Drive

Explains how to set up the snowthrower for freewheeling or self-propel drive.

Engine Starting and Stopping

Starting the Engine Procedure

Step-by-step guide to starting the snowthrower engine using various controls and components.

Stopping the Engine Procedure

Steps to safely stop the snowthrower engine and ensure all parts have ceased movement.

Controlling Snowthrower Movement

Traction Drive Operation

Instructions on engaging, stopping, and checking the traction drive system.

Speed Selector Operation

Auger/Impeller Drive Operation

Instructions for engaging, stopping, and troubleshooting the auger/impeller drive.

Quick Stick Operation for Chute

Quick Stick Operation for Deflector

Problem Resolution and Prevention

Unclogging the Discharge Chute

Procedure for clearing blockages in the discharge chute using safe methods.

Operating Tips and Maintenance Schedule

General Operating Tips and Precautions

Recommended Maintenance Schedule

Outlines required maintenance tasks and their service intervals.

Maintenance Procedures

Checking Engine Oil Level

Instructions for checking the engine oil level and adding oil if necessary.

Adjusting Skids and Scraper

Adjusting Traction Cable

Cable and Component Adjustments

Auger/Impeller Cable Adjustment

Gearbox and Engine Oil Maintenance

Auger Gearbox Oil Level Check

Engine Oil Change Procedure

Steps for draining old engine oil and refilling with fresh oil, including oil type and capacity.

Spark Plug and Chute Latch Adjustments

Spark Plug Inspection and Replacement

Discharge Chute Latch Adjustment

Replacing Drive Belts

Troubleshooting Engine Issues

Electric Starter Problems

Engine Starting Difficulties

Covers causes and solutions for engine starting difficulties.

Rough Engine Operation

Troubleshooting Snowthrower Performance

Poor Snow Discharge

Diagnoses and corrects issues related to poor snow discharge performance.

Discharge Chute Malfunctions

Ineffective Snow Clearing