EasyManua.ls Logo

Toro 38621 Power Max 826LE - Storage; Preparing the Snowthrower for Storage; Removing the Snowthrower from Storage

Toro 38621 Power Max 826LE
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Storage
Gasoline v apor s can explode.
Do not stor e gasoline mor e than 30 days.
Do not stor e the sno wthr o w er in an enclosur e
near an open flame.
Allo w the engine to cool bef or e storing it.
Preparing the Snowthrower
for Storage
1. On the last refueling of the year , add fuel stabilizer to
fresh fuel as directed b y the engine man ufacturer .
2. R un the engine for 10 min utes to distribute the
conditioned fuel through the fuel system.
3. Loosen the hose clamp that secures the fuel line to the
v alv e and slide the fuel line off the fuel shutoff v alv e .
4. Open the fuel shutoff v alv e and allo w the fuel to drain
out of the fuel tank into an appro v ed fuel container .
5. Install the fuel line onto the fuel shutoff v alv e and
secure it with a hose clamp .
6. R un the sno wthro w er until the engine stops from
r unning out of fuel.
7. Prime the engine and star t it ag ain.
8. Allo w the engine to r un until it stops . W hen y ou can no
long er star t the engine , it is sufficiently dr y .
9. Stop the engine and allo w it to cool.
10. R emo v e the ignition k ey .
11. Disconnect the spark plug wire .
12. R emo v e the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole , and pull the star ter rope slo wl y
sev eral times to distribute oil throughout the cylinder to
prev ent cylinder cor rosion during the off-season.
13. Loosely install the spark plug .
14. Dispose of any un used fuel properly . R ecycle it
according to local codes , or use it in y our automobile .
Note: Do not store stabilized fuel for more than
90 da ys .
15. Clean the sno wthro w er thoroughly .
16. Tighten all loose screws , bolts , and loc kn uts . R e pair or
re place any damag ed par ts .
Removing the Snowthrower
from Storage
1. R emo v e the spark plug and spin the engine rapidly using
the star ter to blo w the ex cess oil from the cylinder .
2. Install the spark plug b y hand and then tor que it to
15 ft-lb (20.4 N·m).
3. Connect the spark plug wire .
4. P erfor m the ann ual maintenance procedures as gi v en in
the R ecommended Maintenance Sc hedule .
20

Related product manuals