Toro 38621 Power Max 826LE - Setup; Loose Parts; Installing the Upper Handle; Installing the Traction Control Linkage

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Handle bolts
4
Curved washers
4
1.
Locknuts
4
Install the upper handle.
2.
No parts required
–
Install the traction control linkage.
Carriage bolts
2
3.
Locknuts
2
Install the chute control rod.
4.
No parts required
–
Fill the engine with oil.
5.
No parts required
–
Check the tire pressure.
6.
No parts required
–
Check the skids and scraper.
1. Installing the Upper Handle
Note: Do not remo v e the r ubber band until y ou ha v e
installed the upper handle .
1. Lift and rotate the upper handle and position it o v er
the lo w er handle ( Figure 3 ).
Important: R oute the ca bles attached to the
Quick Stick inside the upper handle legs and
ensur e that the ca bles and the wir e f or the headlight
ar e not pinched betw een the handle sections.
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts , 4 cur v ed
w ashers , and 4 loc kn uts from the loose par ts bag ( Figure
4 ).
Figure 4
2. Installing the Traction
Control Linkage
1. R emo v e the hair pin cotter and w asher from the lo w er
end of the speed control rod and inser t the lo w er end
of the rod into the lo w er link ar m so that the bent end
of the speed control rod faces rearw ard ( Figure 5 ).
6