TROUBLE SHOOTING (Cont.)
CONDITION CAUSE CORRECTION
Tire(s) Skidding (cont.) •
Check the pressure setting on
the relief valve (1100 PSI) it
may be too low. Reset, if nec-
essary.
•
Uneven tire pressure
•
Check tire pressure. All tires
should be 20 PSI.
Conveyor Belt Not Tracking
Properly
•
Belt pulls to one side
•
Tension is not the same from
side to side. Set the spring
rod at 4 1/2" on both sides.
Run. The belt will pull to the
tight side. Loosen or tighten
as needed.
•
Belt Buckles in Center
•
Pulleys are not in line. Re-
move belt lacing and realign
the pulleys using straight
edge or fixture.
•
Belt rides off pulley
•
V-Guides of the belt not cor-
rect. Measure distance be-
tween v-guides for straight-
ness and squarness. Toler-
ance for both is (+) or (-) 1/16".
Uneven Sand Distribution
•
Uneven tire pressure
•
Check both outside tire pres-
sure; both tires should be 20
PSI.
•
Uneven brush setting
•
Check brush to conveyor belt
adjustment. Brush should be
same height all the way
across face.
•
Excessive air in the system
•
Bleed lines. See Operators
Manual for instructions.
•
Not enough air in oil tank
•
Pressurize air in tank to 35
PSI.
To Next Page
Loading...
