SEASONAL STORAGE
1. Thoroughly clean the topdresser, especially
inside the hopper. The hopper and conveyor belt
area should be free of any remaining sand
particles.
2. Apply a light coat of silicone to the lacing of the
conveyor belt. Refer to Maintenance section
3. Inflate all tires to 20 PSI. Or block up the
topdresser to remove the weight.
4. Drain and replace hydraulic fluid and filter.
Inspect all hydraulic lines and fittings. Replace if
necessary. Refer to the Maintenance section.
5. Tighten all fasteners.
6. Lubricate all grease fittings and bearings. Wipe
off excess lubricant. Refer to page 10.
7. The unit should be stored out of the sun to
prolong the life of the conveyor belt. If stored
outside it is recommended to cover the hopper with
a tarp.
8. Check the tension of the drive chain. Adjust the
tension if necessary and lightly coat the chain with
grease. Refer to the Maintenance section (pg. 11
- 13).
IDENTIFICATION AND ORDERING
MODEL AND SERIAL NUMBER
The TOPDRESSER 2300 has two identification
numbers: a model number and serial number. The
two numbers are stamped on a plate which is
riveted on the hydraulic tank. In any
correspondence concerning the TOPDRESSER
2300, supply model and serial numbers to be sure
that the correct information and replacement parts
are obtained.
To order replacement parts from an authorized
TORO Distributor, supply the following
information:
1. Model and serial numbers of the machine.
2. Part number, description and quantity of parts
desired.
Note: Do not order by reference number if a parts
catalog is being used; use the part number.
18
To Next Page
Loading...
