Toro 44501 - User Manual

Questions and Answers

H
hartjoshuaAug 1, 2025
Why is my Toro Lawn and Garden Equipment conveyor belt not turning?
- E
  Erin WilliamsAug 2, 2025
  There are several reasons why the conveyor belt might not be turning. The chain may be loose or broken, requiring replacement or tension adjustment. The belt tension could also be too loose, so tighten it. If the brush is set too low, slide a sheet of paper between the brush and the belt; it should slide freely. If the brush is too low slide it upwards until it clears the belt just enough to slide the paper underneath, ensuring clearance at the lacing. Lastly, the drive roller might not be turning; inspect the welds on each end of the drive roller, as the shaft may be turning but not the roller, which would necessitate drive roller replacement.
M
Matthew WilliamsAug 10, 2025
What to do if the conveyor belt and brush are not turning on my Toro Lawn and Garden Equipment?
- R
  richard08Aug 11, 2025
  If the conveyor belt and brush are not turning, several issues could be the cause. First, check for bad electrical connections by ensuring the wiring harness is plugged in and all wires are making contact. Also, a blown harness fuse could be the culprit, so replace the fuse. Another potential cause is that the hydraulic lines are installed backwards. To correct this, stand on the left-hand side (chain guard side) and ensure the conveyor belt rotates clockwise and the brush rotates counterclockwise. If they are rotating in the wrong direction, reverse the lines on the corresponding motors. Finally, the valve may be contaminated.
A
Andrew FosterAug 21, 2025
What to do if tires are skidding on my Toro 44501 Lawn and Garden Equipment?
- K
  Kenneth SmithAug 21, 2025
  If one tire is skidding, check the sprocket for a sheared key and replace the key if necessary. If both tires are skidding, replace the check valve on that side. Also check the valve for blockage of ports.

Summary

SAFETY INSTRUCTIONS

BEFORE OPERATING

Instructions before operating the unit, including familiarization and checks.

WHILE OPERATING

Safety precautions to follow during operation of the topdresser.

SET UP INSTRUCTIONS

BEFORE OPERATING

CONTROLS

OPERATING INSTRUCTIONS

SAND APPLICATION RATE

How sand application rate is determined and adjusted.

LUBRICATION

MAINTENANCE

BLEEDING HYDRAULIC SYSTEM

Procedure for bleeding the hydraulic system after part replacement.

BRUSH TO CONVEYOR BELT ADJUSTMENT

How to adjust the brush to the conveyor belt for optimal performance.

CONVEYOR BELT INSTALLATION;TENSION

Steps for installing and tensioning a new conveyor belt.

TROUBLE SHOOTING

CONVEYOR BELT AND BRUSH NOT TURNING

Causes and corrections for the conveyor belt and brush not operating.

CONVEYOR BELT NOT TURNING

Troubleshooting steps when the conveyor belt fails to move.

TIRE(S) SKIDDING

Identifying and resolving issues causing tires to skid.

CONVEYOR BELT NOT TRACKING PROPERLY

UNEVEN SAND DISTRIBUTION

Toro 44501 Specifications

General

Engine Type	4-Cycle
Oil Capacity	20 oz
Starter Type	Recoil
Product Type	Walk-Behind Lawn Mower
Clearing Width	22 inches
Engine	Briggs & Stratton
Cutting Width	22 inches
Cutting Height	1.25 - 3.75 in