Toro 53008 - Mixing Gasoline and Oil

12
TORO DOES NOT RECOMMEND
STABILIZERS WITH AN ALCOHOL BASE
SUCH AS ETHANOL, METHANOL OR
ISOPROPYL. ADDITIVES SHOULD NOT
BE USED TO TRY TO ENHANCE THE
POWER OR PERFORMANCE OF
MACHINE.
Mixing Gasoline And Oil
IMPORTANT: The engine used on this String Trimmer
is of a 2–cycle design. The internal moving parts of the
engine, i.e., crankshaft bearings, piston pin bearings
and piston to cylinder wall contact surfaces, require oil
mixed with the gasoline for lubrication.
Failure to add oil to the gasoline or failure to
mix oil with the gasoline at the appropriate
ratio will cause major engine damage which
will void your warranty.
For your fuel premix, only use a quality oil
designed for 2–cycle air cooled engines. Toro
50:1 2–Cycle Oil is formulated to meet the
requirements of high-performance, air-cooled
two-cycle engines.
Fuel Mixture
The fuel:oil ratio is 50 parts gasoline to 1 part oil or 50:1.
Note: Never use a mixing ratio less than 50:1
regardless of the oil package mixing instructions.
Ratios less the 50:1, (for example, 60:1, 80:1, 100:1),
reduce the amount of lubrication to the internal
moving parts of the engine and can cause damage.
Fuel Mixture Chart
Gasoline 50:1 2-cycle oil
1 gallon 2.6 oz.
2 gallons 5.2 oz.
5 gallons 12.8 oz.
Mixing Instructions
IMPORTANT: Never mix gasoline and oil directly in
the String Trimmer fuel tank.
1. Always mix fuel and oil in a clean container approved
for gasoline.
2. Mark the container to identify it as fuel mix for the
String Trimmer.
3. Use regular unleaded gasoline and fill the container
with half the required amount of gasoline.
4. Pour the correct amount of oil into the container then
add the remaining amount of gasoline.
5. Close the container tightly and shake it momentarily to
evenly mix the oil and the gasoline before filling the
fuel tank on the String Trimmer.
6. When refilling the String Trimmer fuel tank, clean
around the fuel tank cap to prevent dirt and debris
from entering the tank during cap removal.
7. Always shake the premix fuel container momentarily
before filling the fuel tank
8. Always use a spout or funnel when fueling to reduce
fuel spillage.
9. Fill the tank only to within 1/4–1/2 inch (6mm–13mm)
from the top of the tank. Avoid filling to the top of the
tank filler neck.