EasyManua.ls Logo

Toro 53008 - Troubleshooting Guide

Toro 53008
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Accessories
The following accessories may be purchased at your local
authorized TORO Service Dealer.
1. Single Strap Harness, Model No. 46–2951 and
Deluxe Strap Harness, Model No. 46–2961—safety
release straps made out of durable nylon webbing
(Fig. 30).

Figure 30
1. Red Band
2. Strap
3. Ring
POTENTIAL HAZARD
Without the Brushcutter blade shield installed
on the String Trimmer, the Brushcutter blade
can throw foreign objects.
Without the correct blade shield, handles and
strap installed on the String Trimmer, the
Brushcutter can produce side thrust which can
expose the operator and bystanders to blade
contact.
WHAT CAN HAPPEN
Contact with the Brushcutter blade or thrown
objects can cause severe personal injury.
HOW TO AVOID THE HAZARD
Never install only a Brushcutter blade onto a
String Trimmer.
To convert a String Trimmer to a Brushcutter,
you must purchase and install the entire
Brushcutter Accessory Kit.
Troubleshooting
Problem Cause Action
Engine Will Not Start
STOP switch set to off position
Empty fuel tank
Move switch to on position
Fill fuel tank
Primer bulb wasn’t pushed enough Press primer bulb until fuel flows
through fuel return line
Engine flooded Use warm engine starting
procedure
Engine Will Not Idle Idle speed set incorrectly Set idle speed
Engine Lacks Power or Stalls When
Cutting
Throttle wire has come loose Tighten throttle wire
Cutting
Dirty air filter Clean or replace air filter
If further assistance is required, contact your local authorized Toro service dealer.

Related product manuals