Toro 53008 - Hot Engine Restart

14
Hot Restart
To start an engine that is already warmed up (hot restart),
or if the ambient temperature exceeds 68_F (20_C):
1. Pump the primer bulb at the bottom of the carburetor
until fuel can be seen flowing through the fuel return
line to the fuel tank (Figs. 11).
2. Move the choke lever to the open (
) position and
move the stop switch to the “ON” position (Figs. 11
and 12).
3. Leave the throttle trigger in the idle position and pull
the starter handle (Figs. 11 and 12).
4. If the engine fails to start after three to four pulls,
follow the instructions in the Cold Starting Procedure
section above.
If the engine fails to start after you follow the above
procedures, contact an authorized Toro dealer.
To Stop The Engine:
1. Release the throttle trigger (Fig. 12).
2. Slide the stop switch to the “STOP”
position (Fig. 12).





Figure 12
1. Stop Switch
2. Fast-idle Lock
3. Throttle Trigger (in
fast-idle start position)
4. Throttle Trigger (in idle
position)