Toro 74408 Z334 Z Master - Stopping the Machine; Adjusting the Height-Of-Cut; Using the Lift Assist Pedal

Toturn,releasepressureonthemotioncontrollever
towardthedirectionyouwanttoturn(Figure14).
Tostop,pushthemotioncontrolleverstothe
neutralposition.
StoppingtheMachine
Tostopthemachine,movethetractioncontrollevers
tothecenterpositionandmovethemouttothelocked
position,disengagethepowertakeoff(PTO),andturn
theignitionkeytooff.
Settheparkingbrakewhenyouleavethemachine;refer
toSettingtheParkingBrakeinOperation,page11.
Remembertoremovethekeyfromtheignitionswitch.
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethetractorwhileit
isunattended.
Alwaysremovetheignitionkeyandsetthe
parkingbrakewhenleavingthemachine
unattended,evenifjustforafewminutes.
AdjustingtheHeight-of-Cut
Theheight-of-cutisadjustedfrom1to5inch
(25to127mm)in1/4inch(6mm)incrementsby
relocatingtheclevispinintodifferentholelocations.
1.Raisetheheight-of-cutlevertothetransport
position(alsothe5inch(127mm)cuttingheight
position)(Figure15).
2.Toadjust,removetheclevispinfromthe
height-of-cutbracket(Figure15).
3.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
inserttheclevispin(Figure15).
4.Movethelevertotheselectedheight.
Figure15
1.Heightofcutholes2.ClevisPin
UsingtheLiftAssistPedal
Theliftassistpedalisusedforraisingthemowerdeck.
Thisallowsforeasierraisingofthemowerdeck.
1.Placeyourfootontoliftassistlever.
2.Pressontheliftassistleverwhilepullinguponthe
height-of-cutlever(Figure16).
Figure16
1.LiftAssistpedal2.Height-of-cutlever
17