EasyManua.ls Logo

Toro 74901 - Brake Maintenance; Adjusting the Parking Brake

Toro 74901
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BrakeMaintenance
AdjustingtheParkingBrake
ServiceInterval:Aftertherst100hours
Every500hours
DANGER
Mechanicalorhydraulicjacksmayfailtosupport
machineandcauseaseriousinjury.
Usejackstandwhensupportingmachine.
Donotusehydraulicjacks.
Checktomakesurethebrakeisadjustedproperly.
1.Drivethemachineontoalevelsurface.
2.Disengagethebladecontrolswitch(PTO),movethe
motioncontrolleverstotheneutrallockedposition
andsettheparkingbrake.
3.Stoptheengine,waitforallthemovingpartstostop,
andremovethekey.
4.Raisethebackofthemachineupandsupportthe
machinewithjackstands.
5.Removethereartiresfromthemachine.
6.Removeanydebrisfromthebrakearea.
7.Openthedrivewheelreleasevalves.RefertoUsing
theDriveWheelValvesinOperation.
8.Disengagetheparkingbrake.
9.Usinghandsandngersonly,pushthecaliperlever
armtoengagethebrakepadsontherotoruntilthe
leverstops(
Figure74).
Notetheorderofthestandardnutandlocknut.
10.Whileholdingtheleveratthestoppedposition,use
theotherhandorngerstopullthecablethreaded
endtightthroughtheswivel.Spinthestandardnut
againsttheswivel(
Figure74).
11.Trytoturnthewheelhubinbothdirectionsrelative
tothecaliper.Thereshouldbeslightmovement
betweenthem;somefriction/resistanceisacceptable.
12.Ifthereisnomovementbetweenthehubrotorand
thecaliperthenbackoffthestandardnutoneturn
fromtheswivelandrepeatstep11
13.Ifthehubrotormovesveryfreelyrelativetothe
caliper,thentightenthestandardnutoneturn
againsttheswivelandrepeatstep
11
14.Oncestep11isachieved,holdthethreadedrod
endwithatoolandtightenthelocknutagainstthe
standardnut.DoNotallowthecabletoturnwhen
thenutsaretightened.
15.Closethedrivewheelreleasevalve.RefertoUsing
theDriveWheelValvesinOperation.
16.Repeatontheoppositesideofthemachine.
17.Installthereartiresandtorquethelugnutsto90-95
ft-lb(122-129N-m).
18.Removejackstands.
Figure74
LeftHandBrakeShown
1.Cableanchor
6.Locknut
2.Threadedrod7.Pullcablethreadedrod
thisdirection
3.Pushleverthisdirection8.Holdthreadedrodhere
4.Caliperleverarm9.Swivel(pivothead)
5.Standardnut(shown
againstswivel)
49

Table of Contents

Related product manuals