To Next PageTo Next PageWhy does the starter not crank on my Toro 74904 Lawn Mower?
If the starter on your Toro Lawn Mower isn't cranking, make sure the blade-control switch (PTO) is DISENGAGED, the parking brake is set, and the drive levers are in the NEUTRAL-LOCK position. Ensure you are seated and that the battery isn't dead; charge it if necessary. Check the electrical connections for good contact, and replace the fuse if it's blown.
What to do if my Toro 74904 Lawn Mower won't drive?
If your Toro Lawn Mower isn't driving, check these items: * Ensure the bypass valves are tightly closed. * Change the pump belt if it is worn, loose, or broken. * Change the pump belt if it is off a pulley. * Replace the idler spring if it is broken or missing. * Add hydraulic oil to the reservoirs or allow it to cool down if the hydraulic oil level is low or too hot.
Why won't my Toro 74904 starter crank?
If the starter on your Toro Lawn Mower doesn't crank, there are several possible reasons. First, ensure the blade control switch (PTO) is disengaged and the parking brake is set. Also, make sure the drive levers are in the neutral lock position and that you are seated on the seat. If these aren't the problem, check if the battery is dead and charge it if necessary. Inspect the electrical connections for corrosion or looseness, and replace the fuse if it's blown.
What to do if the clutch does not engage on my Toro 74904?
If the clutch does not engage on your Toro Lawn Mower, start by replacing the fuse if it is blown. Check the coil resistance, battery charge, charging system, and wiring connections, and replace components if necessary. Also, check the coil and replace the clutch if it is damaged. Repair or replace the clutch lead wire or electrical system if there is inadequate current supply, and clean the connector contacts. Finally, remove the shim or replace the clutch if the rotor/armature air gap is too large.
Why is my Toro 74904 vibrating so much?
If your Toro Lawn Mower is vibrating abnormally, several components could be the cause. Check the cutting blades for bending or imbalance and install new ones if necessary. Ensure the blade mounting bolt and the engine mounting bolts are tightened securely. Inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley. For issues such as a damaged engine pulley, a bent blade spindle, or a loose/worn motor mount, contact an Authorized Service Dealer.
Why aren't the blades rotating on my Toro Lawn Mower?
If the blades on your Toro Lawn Mower aren't rotating, check the following: replace the deck belt if it is damaged, worn, loose, or broken. Install the mower belt on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Check the belt tension or install a new belt if the pump drive belt is worn, loose, or broken. Replace the spring if the idler spring is broken or missing.
Why does my Toro Lawn Mower pull to the left or right?
If your mower pulls to one side, the tracking may need adjustment, or the tire pressure in the drive tires may not be correct. Adjust the tracking and the tire pressure in the drive tires.
What causes the blades to not rotate on my Toro Lawn Mower?
If the blades on your Toro Lawn Mower do not rotate, it could be due to a damaged, worn, loose, or broken mower deck belt; install a new deck belt. Ensure the mower deck belt is properly installed on the deck pulley, checking the idler pulley, idler arm, and spring for correct position and function. Also, a worn, loose, or broken pump drive belt can cause this issue, so check the belt tension or install a new belt. Finally, check the idler spring and replace it if it is broken or missing.
What to do if the blades do not rotate on my Toro 74904?
If the blades do not rotate on your Toro Lawn Mower, install a new deck belt if the mower deck belt is damaged, worn, loose, or broken. Install the mower belt on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function if the mower deck belt is off the pulley. Check the belt tension or install a new belt if the pump drive belt is worn, loose, or broken. Replace the spring if the idler spring is broken or missing.
What to do if my Toro 74904 engine does not start?
If your Toro Lawn Mower engine doesn't start, starts hard, or fails to keep running, several factors could be at play. First, ensure the fuel tank isn't empty and the fuel-shutoff valve is open. Check that the oil level in the crankcase is sufficient and the throttle is positioned midway between the SLOW and FAST settings. Also, a dirty fuel filter or air cleaner can cause issues, so replace or clean them as needed. Inspect the spark plug, adjusting or replacing it if it's fouled or improperly gapped, and verify the spark-plug wire is securely connected. Finally, check the seat-switch indicator, replacing the seat if necessary.
General| Brand | Toro |
|---|---|
| Model | 74904 |
| Category | Lawn Mower |
| Language | English |
