Toro 74915 Z Master G3 - Stopping the Machine; Adjusting the Height of Cut

StoppingtheMachine
Tostopthemachine,movethetractioncontrollevers
toneutralandmovetolockedposition,disengagethe
powertakeoff(bladecontrolswitch(PTO),andturn
theignitionkeytooff.
Settheparkingbrakewhenyouleavethemachine;refer
toSettingtheParkingBrakeinOperation.Remember
toremovethekeyfromtheignitionswitch.
CAUTION
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethetractorwhileitis
unattended.
Alwaysremovetheignitionkeyandsettheparking
brakewhenleavingthemachineunattended,even
ifjustforafewminutes.
AdjustingtheHeightofCut
UsingtheTransportLock
Thetransportlockhastwopositionsandisusedwith
thedeckliftpedal.Thereisalockpositionandaunlock
positionforthetransportposition.Thetransportlock
isusedwiththedeckliftpedal.RefertoFigure26
Figure26
TransportLockPositions
1.Transportlock3.Unlockposition—doesnot
lockthemowerdeckinto
transportposition
2.Lockposition—mower
deckwilllockintotransport
position
23